Phonewell Acoustic Insulation by Acara Concepts Unrivalled Acoustic Insulation  
Soundproofing with Phonewell Acoustic Insulation - The Natural Sound Insulation - Phonewell® data sheet

Stockists throughout the UK and Ireland. Contact UsTEL:IRE + 353 (0)1 8409 286UK 07985 195667

The BBA has awarded the Phonewell Sound Insulation their prestigious Agrement certificate for 'fit for purpose' in building construction and has been accepted by NHBC for use in New Build Development with life time longevity.

Home
About Phonewell®
Technical Data
Applications
Soundproofing Walls
Soundproofing Floors
Soundproofing Ceilings
Timber Frame
Steel Studding
Solid Block
Gallery
Soundproofing Tips
Cutting Phonewell®
Finish Surfaces
Flanking Noise
Links
Site Map
Contact us

See us at:

See us and our ecological Soundproofing and thermal insulation products at the EcoShow live at the King's Hall Belfast 8-10 October 2010




Cutting & Taping Phonewell Sound Insulation

 
 

Site Conditions:

  • Phonewell® must be stored in a dry location
  • Phonewell® must be stored flat
  • The building structure should be watertight (unless offsite instructions adhered to)
  • Acclimatise Phonewell® in the fitting location
  • Read all instructions prior to fitting
  • If in doubt, call the Phonewell® support team
 
 

Cutting Phonewell®:

 
  Phonewell® is a cross fluted engineered carcass with a finely compacted loose filler material inside and as such must be taped, to reseal, when cut.  
 

Phonewell cross cut carcass with sand mixture

 
 
  • Ensure careful handling to minimise filler spillage
  • Always cut with Phonewell® laid flat
  • Use a straight edge for guidance
  • Cut with a knife, jigsaw or a circular saw
    (use a ceramic tile, tungsten carbide grit jigsaw blade or general purpose tungsten carbide fine tooth circular saw blade for longevity).
  • Immediately seal all cut edges with Phonewell® Eco-Tape while board is vertical (see ‘Taping Phonewell…’).
 
 

Taping Phonewell® Cut Edges with Phonewell® Eco-Tape in Seconds

 
 

Please note, Phonewell® cut edges must be immediately taped, to seal, after each single cut.

Cutting Phonewell stages 1 to 3
 
 

Hold the cut edge upwards.
Roll out the tape with a 3 to 5cm overhang at each side.

Press and smooth the tape onto the cut edge.

Tear the tape to length.

 
 
Taping Phonewell stages 4 to 6
 
 

Press and smooth the tape down both edges.

Press and smooth the tape down both front and back faces.

Fold in the remaining wings onto both front and back faces.

 
 

A professionally cut and taped Phonewell® board in a few seconds.

Taping Phonewell stage 7
   
 
Back to Top
Sound Insulation the Natural Way
The Highest Airborne Sound Reduction Impact Sound Reduction Outstanding at Low Frequencies; Correction Factor Sound Insulation at only 15mm thick